What should we pay attention to when processing metal precision parts?


1. Check whether the moving part is filled with lubricating oil before mechanical work, and then start and check whether the clutch and brake are normal, and run the machine for 1-3 minutes. It is forbidden to operate when the machine is faulty.

2. Work to maintain the correct posture, to have enough spirit to cope with the work, if you find physical discomfort to leave the job immediately, and report to the leadership. It is forbidden to chat and cooperate with each other during operation. The operator should not operate in a state of irritability and fatigue to avoid accidents and ensure operation safety. All employees should check whether their clothing meets the requirements of work before entering the job. Do not wear slippers, high heels and safety clothing, long hair to wear a helmet.

3. When replacing the mold, first turn off the power, press movement department stops running, can start to install and debug the mold. After the installation and adjustment, test the flywheel twice by hand to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the blank holder is in a reasonable position.

4. Must wait for other personnel all leave the mechanical working area, and take away the sundries on the work table, can start the power supply to start the machinery.

5. When mechanical work, it is forbidden to stretch your hand into the slider working area, and it is forbidden to take or release work parts by hand. Standard tools must be used when taking and releasing work parts from the die. If the machine has abnormal sound or malfunction, the power switch should be turned off immediately for inspection. After the machine starts, one person shall transport materials and operate the machine. Other people shall not press the power construction or step on the pedal switch board, let alone put their hands into the mechanical working area or touch the moving part of the machine with their hands.

6. When off work, should turn off the power supply, and sort out the finished products, side materials and sundries on the post, to ensure that the working environment is clean and safe.

1635577389374137.jpg